CALL A.WIHARTA 081294124885 085778084789 087784022201   Info Produk Standard Features: 4 model sizes 32, 39, 53 and 108 litres temperature range from + 5° C up to + 60° C forced ventilation by Peltier fan casing and working chamber of stainless steel material 1.4301 double doors – inner glass door, outside stainless steel door adjustable microprocessor overheat controller ( TWW) protection class 3.1 according to DIN 12 880 and additional mechanical temperature limiter serial interface RS 232 incl. MEMMERT-software „ Celsius 2000“ parallel printer interface for EPSON ESC/ P2-compatible printers chip-card control incl. 1 MEMory CARD XL works calibration certificate for 37° C Control and Heating Concept: Peltier-heating-/ cooling system ( heat pump principle) integrated in the rear adaptive, fuzzy-supported PID-microprocessor controller temperature setting and LED temperature display with 0, 1° C resolution multifunctional programming through 5-digit LED digital display Advantages compared to compressor-type cooled incubators: reduction of energy consumption of up to 90% ( ! ) remarkable temperature distribution being better than + / - 0, 3° C ( from 10 – 37° C) and variation of temperature with time of approx. + / - 0, 05° C no refrigerant thus no special arrangements for disposal minimal emission of noise inevitable condensation due to physical reasons does not take place in the working chamber ( water droplets) but outside in the cooling unit of the Peltier module High-performance compressor-type cooled incubators are recommended for temperatures below 5° C short cooling-down times for breeding bigger quantities requiring larger working chambers – so far Peltier-technology is not yet economical for this application